浴室的要求
湿区干区
1、湿区干区
必须隔开,电源控制开关必须装在干区。
2、淋浴区地面
淋浴区的地面必须做好防水处理,铺饰防滑瓷砖。
建筑的要求
3、天花厚度豪华头顶花洒,自身净重 25KG,通水淋浴时会达到
35KG 以上。因此天花的厚度必须在 15CM 以上, 且天花材料
也要有足够的强度。
4、 天花高度天花的高度须在 2.3M 以上,以免影响淋浴享受效果、
浴室 的美学效果。
5、墙体厚度墙体厚度须在 15CM 以上,以保证暗置龙头的预埋、
安装。
给排水的要求
6、热水供应
最大工作水压 :0.8Mpa;
理想工作水压 :0.25-0.45Mpa;
最高水温 :70℃ ;
理想水温:15℃ -65℃
最低热水保障量 : 连续使用该淋浴系统的人
数是最终的决定因素;
为保证一个人充分的享受该淋浴系统,热水
最低障量至少在 250L 以上。
7、龙头进出水连接管
两根 3/4”( 冷、热 ) 进水管五根 1/2“混合
水出水管
8、排水系统
排水系统每分钟最低排水量在 60L 以上。
注意 : 所有水管在连接至淋浴系统任何组件 ( 龙头、头顶花洒、体位花洒等 )
前都必须先通水清除杂质,以免造成淋浴系统组件的堵塞、损伤。
电源的要求
9、 电源线
5X1.5MM2
10、电源控制
开关必须安装在干区
提醒 : 建议安装故障电流保护装置,保险装置额定电流 30mA; 苍穹系列灯
光头顶花洒,内置有电源变压器变压至 12V 安全电压。
Bathroom requirements
Wet area dry area
1. Wet area and dry area
Must be separated, power control switch must be installed in the dry zone.
2. Shower area floor
Shower area floors must be waterproof and covered with non-slip tile.
Architectural requirements
3, smallpox thickness luxury head shower, its own net weight of 25KG,
the water will reach the shower More than 35KG. Therefore, the
thickness of smallpox must be more than 15CM, and smallpox material
It has to be strong enough.
4, the height of smallpox must be above 2.3M, so as not to affect the effect
of the shower,The aesthetic effect of the bathroom.
5. Wall thickness The wall thickness must be above 15CM to ensure the
embedment of the hidden faucet.Install.
Requirements for water supply and drainage
6. Hot water supply
Maximum working water pressure :0.8Mpa;
Ideal working water pressure :0.25-0.45Mpa;
Maximum water temperature :70℃ ;
Ideal water temperature: 15℃ -65℃
Minimum hot water allowance: For continuous use of the shower system
Numbers are the ultimate determinant;
To ensure a person's full enjoyment of the shower system, hot water
Minimum barrier at least 250L above.
7. Tap inlet and outlet water connection pipe
Mix two 3/4 \"(hot and cold) intake pipes and five 1/2\" Water outlet pipe
8. Drainage system
The minimum displacement of the drainage system is above 60L per
minute.
Note: All pipes must be drained to remove impurities before connecting to any
component of the shower system (faucet, overhead shower, position shower, etc.) to
avoid clogging and damage to the shower system components.
Requirements for power supply
9. Power Cord
5 the x1. 5 was
10. Power control
The switch must be installed in the dry zone
Reminder: It is recommended to install fault current protection device, rated
current of the safety device 30mA; Sky series lights overhead shower, built-in power
transformer to 12V safe voltage.
规划条件
热进水管
冷进水管
混合水管