06
08
10
07
09
工艺流程 Process flow
Production Process 生产流程
06
1. 抛光
这个过程分为两部分，亚麻轮抛光和布轮抛光，亚麻轮抛光是粗
抛光，有效去除线面细小的横纹、毛刺和轻微的机械纹；布轮抛
光，是一种精细的抛光工艺，是去除磨痕阶段，保证线条表面光
滑，达到镜面效果。
2. 喷砂
通过调整砂流清理的影响和粗化工艺的基本表面，采用不锈钢德
国进口钢砂，粒度均匀，保证线面油污，机械去粒干净，哑面饱
和，高贵的质地。
3. 氧化
染色工艺对时间、温度、染料浓度、墨粉质量和 pH 值有严格的
要求，会直接影响线条的色差。
表面处理Surface Treatment Color hole sealing
Cut and fold
Placing
Finished product packing
1. Polishing
This process is divided into two parts, linen wheel polishing
and cloth wheel polishing, linen wheel polishing is coarse
Polishing, effectively removing small horizontal lines, burrs and
slight mechanical lines on the line surface; cloth wheel polishing
Light is a fine polishing process. It is the stage of removing
the wear marks to ensure the smooth surface of the line.
Sliding to achieve a mirror effect.
2. Sandblasting
By adjusting the impact of sand flow cleaning and the basic
surface of the roughening process, stainless steel is used.
T h e s t e e l g r i t i m p o r t e d f r o m C h i n a h a s u n i f o r m
particle size, ensuring oil stains on the line surface,
clean mechanical de-graining, and full dumb surface
And, noble texture.
3. Oxidation
The dyeing process is strict with time, temperature,
dye concentration, toner quality and pH value
Requirements, will directly affect the color difference of the line.
07
08
09
10
染色后必须封线，封口分为常温封口和中温封口。 密封性决定了管线的耐候性。
取下铝线，整齐排列在支架上晾干。线是氧化过程的产物，在生产过程中需要小
心处理。需要单个棉花分离器。
公司修边人员用切割机对产品进行切割对应的长度，去除表面装订和左装订标记，
确保小装订产品整个切割的完整性和光滑度。
公司仓库人员使用手推车、叉车进入成品仓库，垂直和水平放入仓库。
颜色封孔
放置
剪切和折叠
成品包装
Lines must be closed after dyeing, The sealing is divided into normal
temperature sealing and medium temperature sealing. The sealing
determines the weatherability of the line .
Remove the aluminum lines and arrange them neatly on the support to air
dry. The lines are products of oxidation process, which need to be handled
with care during production. A single cotton separator is required.
The trimming staff of the company use the cutting machine to cut the
product to the corresponding length, remove the surface binding and left
binding marks, to ensure the integrity and smoothness of the entire cutting
of the small binding product.
warehouse personnel of the company use carts and forklifts to enter the
finished products warehouse, and put them into the warehouse vertically
and horizontally.
Quality in quality - Quantity in stars XINGON 8
