AWNINGS
ONE-PIECE
SNAP
1.This product is made of environmentally friendly PVC material,
from ink, accessories to finished products, in line with EU EN71
environmental standards.
2.The baby's back shoulder strap can be arbitrarily adjusted
to reduce skin friction. Side protective air bag, double protective
buckle, make the baby safer.
3.The comfortable support design is filled with sponge, and the
anti-slide pocket design effectively prevents the baby from slipping.
4.The product has a total of 5 airbags, all the airbags should be full
of gas, so that it is fully full.
5.This product is suitable for babies from 3 months to 36 months.
1 2
3 4
WARNING
BF-229
Product is not a life-saving device and should be used in
shallow water under adult supervision and never left. Do not
touch sharp objects, over-inflate or use high pressure. Do
not over-inflate or use high air pressure to inflate.
This product is made of high temperature resistant material.
Therefore, no harmful substances will be released in 100℃
boiling water. However, for the safety of your baby, the
first one should be put in cold water and the second one
should be put in hot water, please make sure the water
temperature is 36Please make sure the water temperature is
around 36~38℃.
PRODUCTINSTRUCTIONS
This product in the winter ambient temperature is lower
than 8 ℃, there will be material hardening and brittle, before
inflation Please use warm water below 50℃ or soften it in
a warm room for 2-3 hours before use.
SPECIAL REMINDER
PRODUCT STRUCTURE DIAGRAM
SIDE PROTECTION
AIRBAGS
INNER RING
AIRBAG
OUTER RING
AIRBAG
CORD FASTENER
PRODUCT CHARACTERISTICS
AIR NOZZLE INSTRUCTIONS CHARGING PROCEDURE
Hold the breath
nozzle
Open your mouth
Pump with an inflator
Or blow
Press the nozzle into
the bag
Fill the outer ring
airbag first
Then fill the inner
ring with air
Rechargeable side protection
airbags
(The inflation volume is
about 80% to avoid bursting)
Check that the collar is intact and undamaged before inflating. After inflation,
cover the nozzle tightly and press the nozzle into the collar to make the
surface smooth, and then check for air leakage.Check for air leakage.
Let it sit for 20 minutes for all safety checks before letting infants and
toddlers swim in the water. Remember to wash the ring with water after use
to ensure hygiene.avoid leaving the ring in the bathroom or in the sun.
SPECIAL REMINDER
INSTRUCTIONS FOR WEARING
Step 1
Insert the protective
airbag clips on both sides first
Step 2
Then insert the
front shoulder catch
In order to avoid baby's sunburn when using the swimming ring
outdoors, you can connect the four snaps on the awning to the
swimming ring.(There are elastic wires inside the awning.
(There are elastic wires inside the awning, please keep it away
from your head and children when you take it out and open
it to avoid bullet injury.)
BABY SWIMMING DOUBLE
RING PLANKING RING
This product is not a
life-saving device
Swimming ring is
approximately 80% inflated
Swimming ring correct
use posture
Must be used under
adult supervision
Do not use
large inflatable tools
Ensure that the nozzle
is always capped and flattened
Manufacture:Putian Zizz Toys Industry & Trade Co.,Ltd.
Address: 210# Houyang Shaxi village,Jiaowei Town,
Xianyou County ,Putian City, Fujian Province ,351252
Mail：service@zizztoy.com
NOTE
This product is warranted for 7 days from the date of purchase for first use only.
When you need to repair, please show the purchaseIf you need to repair,
please present the purchase receipt, if you do not present a valid receipt, our
company will not provide any repair service.
Purchase the product within 7 days to 30 days, and the rupture is less than 10cm
the company can be repaired free of charge, but other costswill be borne
by the customer.
Damage caused by not following the correct use of the product instructions,
after the purchase of human damage and discomfort If you need to repair
the damage caused by human damage or improper storage, you will
be charged accordingly.
FOLDING METHOD
AWNING FOLDING METHODS
Step 1 Step 2
Step 3 Step 4
1.Grab the sides of the canopy
with both hands and twist in
the opposite direction.
2.Keep twisting in the
opposite direction.
3.Twist and turn inward
at the same time.
4.Fold it up and put it in
a plastic bag
